Pioneer DEH-6400BT - Manual (Page 17)

Canceling call waiting
1 Press PHONE.
Adjusting the other party
’s listening volume
1 Turn LEVER while talking on the phone.
! When private mode is on, this function is not
available.
Turning private mode on or off
1 Press BAND/ while talking on the phone.
Switching the information display
1 Press
/ DISP while talking on the phone.
Notes
! If private mode is selected on the cellular
phone, hands-free phoning may not be avail-
able.
! The estimated call time appears in the display
(this may differ slightly from the actual call
time).
Connection menu operation
Important
! Be sure to park your vehicle in a safe place
and apply the parking brake when performing
this operation.
! Connected devices may not operate properly if
more than one Bluetooth device is connected
at a time (e.g. a phone and a separate audio
player are connected simultaneously).
1 Press and hold PHONE to display the
connection menu.
# You cannot operate this step during a call.
2 Turn M.C. to select the function.
After selecting, perform the following proce-
dures to set the function.
Device list (connecting or disconnecting a device
from the device list)
! When no device is selected in the device list, this
function is not available.
1 Press M.C. to display the setting mode.
2 Turn M.C. to select the name of a device you want
to connect/disconnect.
! Press and hold M.C. to switch the Bluetooth
device address and device name.
3 Press M.C. to connect/disconnect the selected de-
vice.
Once the connection is established,
Connected
is displayed.
Delete device (deleting a device from the device list)
! When no device is selected in the device list, this
function is not available.
1 Press M.C. to display the setting mode.
2 Turn M.C. to select the name of a device you want
to delete.
! Press and hold M.C. to switch the Bluetooth
device address and device name.
3 Press M.C. to display Delete YES.
4 Press M.C. to delete a device information from
the device list.
! While this function is in use, do not turn off the
engine.
Add device (connecting a new device)
1 Press M.C. to start searching.
! To cancel, press M.C. while searching.
! If this unit fails to find any available cellular
phones, Not found is displayed.
2 Turn M.C. to select a device from the device list.
! Press and hold M.C. to switch the Bluetooth
device address and device name.
3 Press M.C. to connect the selected device.
! To complete the connection, check the device
name ( Pioneer BT Unit). Enter the PIN code
on your device if necessary.
! PIN code is set to 0000 as the default. You
can change this code.
! 6-digit number appears on the display of this
unit. Once the connection is established, this
number disappears.
! If you are unable to complete the connection
using this unit, use the device to connect to
the unit.
! If three devices are already paired, Device Full
is displayed and it is not possible to perform
this operation. In this case, delete a paired de-
vice first.
En
17
Section
02
Operating
this
unit
Operating this unit