Pioneer AVIC-X1BT - Manual (Page 24)

23
Installation
• Install with the left and right sides of the Hide-away unit perpendicular or par-
allel to your vehicle’s direction of travel. Do not install diagonally to your vehi-
cle’s direction of travel or the current location will be displayed incorrectly.
• Be sure to install the Hide-away unit on the floor with the silk printing side is
facing up. The navigation system will operate properly only in this position.
Installing the Hide-away unit
1. Attach the side brackets to the Hide-away unit.
When the Hide-away unit is installed on the floor or the installation board under the pas-
senger seat, etc., the side brackets should be attached to the unit.
If the positions of the side
plates are shifted in paral-
lel you can also use other
holes that match up with
the holes in the Hide-
away unit.
Hide-away unit
Side bracket
Washer faced screw
(4
× 8 mm)
Use the following holes in
the side brackets.
Forward/Backward
direction of vehicle