Pioneer AVIC-F10BT - Manual (Page 147)

“Rear display” picture disap-
pears.
The source disc being listened to in
the navigation system has been
ejected. Before ejecting the disc, switch the source.
This problem may occur when certain con-
nection methods are used.
There is a problem with the “Rear
display ”, for example a faulty wiring
connection.
Check the “Rear display” and its connection.
An AV source that cannot output to
the rear display is selected. Select an appropriate AV source.
Nothing is displayed and the
touch panel keys cannot be
used. The setting for the rear view camera
is incorrect. Select the appropriate setting for the rear
view camera.
The gearstick was placed in [R]
when the rear view camera was not
connected. Select the correct polarity setting for [ Back
Camera]. (Page 76)
There is no response when the
touch panel key are touched, or
a different key responds. The touch panel keys deviate from
the actual positions that respond to
your touch for some reason. Perform touch panel calibration. (Page 127)
The external storage device
(USB, SD) cannot be used. The USB storage device has been
removed immediately after plugging
it. Park your vehicle in a safe place, and turn off
the engine. Turn the ignition key back to
“Acc
off ”. Then start the engine again, and turn the
power to the navigation system back on.
Problems in the AV screen
Symptom Cause Action (Reference)
CD or DVD playback is not pos-
sible. The disc is inserted upside down. Insert the disc with the label upward.
The disc is dirty. Clean the disc.
The disc is cracked or otherwise da-
maged. Insert a normal, round disc.
The files on the disc are an irregular
file format. Check the file format.
The disc format cannot be played
back. Replace the disc.
The loaded disc is a type this system
cannot play. Check what type of disc it is. (For more cau-
tions about handling each type of media,
refer to Page 160.)
The screen is covered by a cau-
tion message and the video can-
not be shown. The handbrake lead is not con-
nected or applied. Connect the handbrake lead correctly, and
apply the handbrake.
The handbrake interlock is acti-
vated. Park your vehicle in a safe place and apply
the handbrake.
No video output from connected
equipments.
No video output from connected
iPod. [ AV1 Input] or [AV2 Input] setting
is incorrect.
Correct the settings. (Page 124)
The connection of the USB interface
cable for iPod is incorrect. Connect both the USB plug and the RCA
cable side. (If only one of these connection
has been made, the iPod will not work prop-
erly.) (Page 15)
The audio or video skips. The navigation system is not firmly
secured. Secure the navigation system firmly.
Appendix
Engb
147
Appendix
Appendix