Brother MFC-3200C - Manual (Page 8)

6
Setting Up the MFC
8
Gently insert the black ink cartridge in the
black ink position.
9
Press the cover down until it clicks.
0
Repeat Steps 6 to 9 to install each color ink
cartridge. Match the colors of the ink
cartridge covers.
A
Close the top cover and control panel cover.
The MFC will enter a head cleaning cycle for
approximately
four minutes .
• DO NOT remove ink cartridges if you
do not need to replace them. If you
do so, it may reduce the ink quantity
and the MFC will not know the
quantity of ink left in the cartridge.
• DO NOT shake the ink cartridges. If
you do so, the ink may spill when you
take off the sealing tape. If ink stains
your body or clothing, wash with
soap or detergent immediately.
• DO NOT refill the ink cartridges.
Attempting to use refilled cartridges
and using incompatible inks may
cause damage to the print head in
this machine and such damage will
not be covered by warranty.
Warranty coverage does not apply to
problems caused by the use of 3rd
party ink or 3rd party ink cartridges.
Use only genuine Brother ink
cartridges.
1
After the cleaning cycle is finished, the LCD
shows;
2
Make sure the paper is loaded in the paper
tray.
Press the
Black Fax Start key.
3
The MFC starts printing the PRINT
QUALITY CHECK SHEET (only during
initial ink cartridge installation).
CLEANING
7
Color Block Quality and
Alignment Check
PRESS FAX START
■
If you mix the colors by installing an ink
cartridge in the wrong color position, you
must clean the print head several times
after correcting the cartridge installation
and before you start printing.
■
Once you open an ink cartridge, install it in
the MFC and use it up within six months of
installation. Use unopened ink cartridges
by the expiration date written on the
cartridge package.
■ If INK EMPTY shows on the LCD after you
install the ink cartridges, check to make
sure the ink cartridges are installed
correctly.
Check in Step A
Check in Step B
Step 1