New Buck Corporation FS 21 - Manual (Page 27)

Page 25
OPTIONAL MOTOR ASSEMBLY KIT
INSTALLATION INSTRUCTIONS
STEP 1. REMOVE ACCESS DOOR PANEL LOCATED AT BOTTOM OF
UNIT. YOUR MOTOR ASSEMBLY COMES WITH A
BRACKET ALREADY ATTACHED TO THE MOTOR. ALIGN
THE HOLES IN MOTOR BRACKET WITH THE HOLES IN
MOTOR MOUNT. SECURE BRACKET WITH TWO 1/2” HEX
HEAD SCREWS PROVIDED.
STEP 2. REMOVE THE PROTECTIVE BACKING OFF THE
RHEOSTAT INDICATING LABEL AND PLACE THE HOLE IN
CENTER OF LABEL TO LINE UP WITH HOLE IN THE RIGHT
SIDE HEARTH SUPPORT AS YOU FACE THE UNIT. PLACE
LABEL SO “OFF” POSITION IS AT THE 8 O’CLOCK
POSITION AND LOW IS AT THE 4 O’CLOCK POSITION.
MOUNT RHEOSTAT BY PLACING IT BEHIND HEARTH
SUPPORT WITH WIRES ON BOTTOM SIDE. PLACE
PLASTIC STUD THROUGH HOLE IN BRACKET AND
SECURE WITH RHEOSTAT MOUNTING NUT. PLACE
INDICATOR KNOB ON PLASTIC STUD.
STEP 3. REMOVE STRAIN RELIEF COVER FROM HEARTH
SUPPORT AND DISCARD. MOUNT POWER CORD STRAIN
RELIEF HOLDER IN COVER MOUNTING HOLES. PLACE
THERMOSTAT BEHIND “C” CLIP LOCATED UNDER
HEARTH TO THE RIGHT OF MOTOR. USE CABLE TIE TO
SECURE LOOSE WIRES.
STEP 4. REINSTALL ACCESS DOOR PANEL.
STEP 5. PLUG POWER CORD INTO SUPPLY OUTLET. PLACE
RHEOSTAT INDICATING KNOB IN DESIRED POSITION.
WHEN HEATER REACHES TEMPERATURE, FAN WILL
OPERATE AT DESIRED SPEED.
SECTION V