Blaupunkt BOSCH GRUPPE RMD 169 - Manual (Page 33)

68
Programming with DSC
The car radio offers the facility to adjust cer-
tain settings and functions to your require-
ments and to store these changes with the
aid of DSC (Direct Software Control).
The default settings are selected at the fac-
tory.
An overview of the factory default settings
is provided below for future reference.
To alter a programming setting:
•
Press DSC.
Select and adjust the functions described
below by means of the rocker and the ENT
key. The status of adjustment is shown on
the display.
/ Select function
<< / >> Adjust/call up value
ANGLE Adjust the display to your
own viewing angle.
DIM DAY Select the display
brightness for daylight
(Stages 1-9).
DIM NIGHT Select the display
brightness for darkness
(Stages 1-9).
The brightness is switched
over automatically by the
headlights.
TA VOL Adjust the volume of traffic
announcements and the
warning signal from 0 - 66.
Traffic announcements are
played at this volume if the
standard volume is lower.
If the standard volume is
greater than TA VOL, traffic
announcements are played
at the standard volume.
ON VOL Select the initial volume.
Use << >> to select the de-
sired initial volume.
If “LAST VOL” is selected,
the initial volume is the
same as that last selected.
PEAK ON/OFF
Activate/deactivate the dy-
namic volume level display.
SCROLL Appears only in MiniDisc
mode.
If the track name is to run
continuously through the
display, SCROLL ON must
be selected.
REG Appears only in radio mode.
If you wish to receive re-
gional programmes for your
broadcast area, REG ON
must be selected.
SHARX Automatic bandwidth switch-
ing on the FM band.
Where the station density is
high, switch to SHARX ON
with << >>: this largely elimi-
nates interference from ad-
jacent stations.
” SHARX ON” is the default
setting.