Warning this appliance must be earthed, Important fitting a different plug, Electrical requirements – Beko DFN 1000 X User Manual

Page 9

Advertising
background image

8 GB

������������

�������

�����

����������������

��������

Warning

This appliance must be

earthed

If the fitted moulded plug is not suitable

for your socket, then the plug should

be cut off and an appropriate plug

fitted.

Destroy the old plug, which is cut off as

a plug with a bared cord could cause a

shock hazard if inserted into a socket

elsewhere in the house.

The moulded plug on this appliance

incorporates a 13A fuse. Should the

fuse need to be replaced an ASTA

approved BS1362 fuse of the same

rating must be used. Do not forget

to refit the fuse cover. In the event of

losing the fuse cover, the plug must

not be used until a replacement fuse

cover has been fitted. Colour of the

replacement fuse cover must be the

same colour as that visible on the

pin face of the plug. Fuse covers are

available from any good electrical

store.

Important

Fitting a different plug

As the colours of the wires in the

mains lead of this appliance may not

correspond with the coloured markings

identifying the terminals on your plug,

proceed as follows:

1. Connect the green - yellow or

green (earth) wire to the terminal

in the plug marked ‘E’ or with the

symbol

or coloured green

and yellow or green.

2. Connect the blue (neutral) wire to

the terminal in the plug marked ‘N’

or coloured black.

3. Connect the brown (live) wire to

the terminal in the plug marked ‘L’

or coloured red.

With the alternative plugs a 13A fuse

must be fitted either in the plug or

adaptor or in the main fuse box. If in

doubt contact a qualified electrician.

Electrical requirements

Before you insert the plug into the wall

socket make sure that the voltage and

the frequency shown in the rating label

corresponds to your electricity supply.

We recommend that this appliance be

connected to the mains supply via a

suitable switched and fused socket in a

readily accessible position.

If the supply cord or the mains lead

is damaged please do not replace

it by your own. The supply cord or

the mains lead must be replaced by

a Beko Authorized Service Agent

personnel or a similarly qualified

person.

Advertising