BT 150 - Manual (Page 5)

Setting up
5
BT Baby Monitor 150 VTECH – Issue 2 – 27.05.08 – 8796
Parent unit
1. Plug the mains power cable into the socket marked on the
back of the Parent unit charger.
2. Remove the battery compartment cover and insert the 2 x AA
rechargeable batteries into the battery compartment on the
Parent unit and replace the battery compartment cover as
shown. You should always ensure you have inserted batteries
in the Parent unit.
3. Slot the Parent unit into the charger, the red charging light
comes on. Charge the batteries for 16 hours before switching
on the Parent unit.
IMPORTANT
Your BT Baby Monitor 150 is designed
to be an aid and should not be used as
a substitute for responsible and proper
adult supervision.
Make sure the Baby unit, Parent unit
and mains adapter cable are kept out
of reach of your baby – at least one
metre away.
Never place the Baby unit inside your
baby’s cot, bed or playpen.
Never cover your Parent or Baby units
(e.g. with clothes, towels or blankets).
Never use or place your Parent or Baby
units in moist places or near water.
If travelling abroad, make sure that the
voltage shown on the mains power adapter
corresponds to the local mains power
before connecting to the power supply.
There is a risk of explosion if the batteries
are replaced by an incorrect type.
Dispose of used batteries according to
the instructions.
Always dispose of batteries in
accordance with applicable waste
disposal regulations, never in your
household rubbish.
Battery performance - Parent unit
Rechargeable batteries in the
Parent unit give up to 14 hours
continuous performance.
Please note however, that new
batteries do not reach full capacity
until they have been in normal use for
several days.
If you experience any problems, please call the Helpline on 0808 100 6554*
8657 Baby Monitor 150 UG [Vtech 2] 27/5/08 13:03 Page 5