Toshiba SATELLITE P500 - Manual (Page 151)

User’s Manual 8-12
Optional Devices
Setting for display video on HDMI
To view video on the HDMI device, be sure to configure the following
settings. Otherwise, you may find that nothing is displayed.
Settings for audio on HDMI
To set the audio device to use the HDMI:
1. Click Start  Control Panel  Hardware and Sound  Sound 
Digital Output Device (HDMI)  Set Default Device.
To set the audio device to use the internal speakers:
1. Click Start  Control Panel  Hardware and Sound  Sound 
Speakers  Set Default Device.
i.LINK (IEEE1394)
i.LINK (IEEE1394) is used for high-speed data transfer for a range of
compatible devices such as
1. Digital video cameras
2. Hard disk drives
3. MO drives
4. CD-RW drives
Precautions
1. Make a back-up of your data before transferring it to the computer.
There is a possibility that the original data will be damaged. There is a
particular risk that some frames will be deleted in the case of digital
video transfer. TOSHIBA assumes no liability for such loss of data.
2. Do not transfer data in areas where static electricity is easily generated
or in areas subjected to electronic noise. Data can be destroyed.
3. If you are transferring data through an IEEE1394 hub, do not connect or
disconnect other devices from the hub during data transfer. There is a
likelihood that data will be damaged. Connect all devices to the hub
before you turn on the computer’s power.
4. You may not use any copyrighted video or music data copied from a
video camera except for your personal enjoyment.
■ Be Sure to use the FN + F5 hot keys to select the display device
before starting to play video. Do not change the display device while
playing video.
■ Do not change the display device under the following conditions.
■ While data is being read or written.
■ While communication is being carried out.
i.LINK uses a four-pin connector, which does not carry electric current.
External devices will need their own power supply.