Bowflex Ultimate - Manual (Page 95)

A-
Step 8: SEAT INSTALLATION
Locate the following parts for this step:
• Seat Assembly
Pull out and lock the pin on the left side of the seat
assembly and slide the seat onto the rail as shown
in Figure H.
Figure H
14
Unit appears
like this
following this
assembly step
Step 7: SEAT RAIL INSTALLATION
The following parts are required for this
step:
• Seat Rail (Item #10)
• One (1) 3/8”X5” bolt (Item #53)
• Two (2) 3/8” washers (Item #54)
• One (1) 3/8” nylon lock nut (Item #57)
• Large Knob (Item #37)
If you have not already done so, remove
the twist-tie that holds the rail spacer
blocks and tube in place on the side of
the seat rail.
Slide the seat rail, right side up, into the
main frame and rest it on the cross bar as
shown in Figure G.
Slide the 3/8”X5” bolt (Item #53) with a
washer through main frame and seat rail
as shown in Figure G. Place 3/8” washer
(Item #54) and 3/8” nylon lock nut
(Item #57) on bolt and tighten.
Place the large knob (Item #37) into the
hole in the top of the frame and tighten.
Figure G
37
53
54
54
57
Unit appears like
this following this
assembly step
Components for this
step are in Box 3
Assembling Your Bowflex
®
Ultimate
™