Sharp ER-A280F - Manual (Page 115)

113
■ EAN delete
You can delete the EAN codes which have not been accessed during the period you set in this program
when you execute the delete job in EAN DELETE in X1/Z1 mode.
Program each item as follows:
• PERIOD (DAY) (Use the numeric entry)
Enter the EAN record delete period: 01 to 99 (00: Not delete
by the non-accessed deleting job)
Procedure
■ PLU/EAN stock
You can assign a stock quantity to each PLU/EAN code.
Shown below is an example of selecting “1 OVER WRITE.”
After selecting “1 OVER WRITE,” select a pertinent PLU/EAN
code. Then the next screen will appear to show the following
items:
• CURRENT ST
The current stock is displayed.
• NEW STOCK (Use the numeric entry)
Enter a new stock quantity (max. 7 digits: 1 to
9999.999(9999999))
• If you need to add or subtract a stock quantity to or from the
current stock quantity, select “2 ADD” or “3 SUB” and enter a
value to be added or subtracted.
• You cannot enter any values for the item marked with “!”.
• The entry of a new stock value will update to the PLU/EAN stock
counter.
NOTE
Select a pertinent PLU code, or
directly enter a PLU code or EAN
code.
Procedure
▼
▼
ER-A280F_N(SEEG)(E)-6 09.6.18 6:53 AM Page 113