Belkin ScreenCast AV4 - Manual (Page 23)

21
TROUblesHOOTInG anD faQs
What do the leDs on the receiver mean?
Most of the information you need will appear on the TV screen, but
here’s a short list of what the LED light on the transmitter and
receiver can tell you.
Connectivity
How long will it take for my ScreenCast AV system to “wake up”
and connect?
• When turning on the receiver and transmitter, it can take up
to 15 seconds for the devices to connect with one another.
• If you change sources or video resolution, you
may experience up to 10 seconds of connection
time as the devices sync with one another.
• If you are adding an additional transmitter to your ScreenCast
AV system, it can take up to 60 seconds to pair.
note: The ScreenCast AV system comes with the receiver and
transmitter pre-paired so this should not be necessary unless you
add an additional WHDI ™ transmitter or press the reset button long
enough to reset the receiver to factory defaults (5 seconds or more).
When your screenCast
unit is…
The light will be…
starting up Slowly blinking blue
establishing a
connection
Rapidly blinking blue until the connection
is made. If the connection cannot be made
after one minute, the light will blink amber to
show that a connection failure has occurred.
Connected with good
signal strength
Solid blue
Connected with poor
signal strength
Solid amber
Receiving input from
the remote control
The light will rapidly turn on and off until the
remote button is released.