Britax Diplomat - Manual (Page 29)

27
The LATCH harness must be switched
for proper alignment in rear facing (Fig.
D) or forward facing (Fig. E) installations.
Complete the following procedure to switch
the connectors.
NOTE: LATCH connectors must be in an upright
position (as shown in figure G) and strap should be
tight and not twisted to ensure proper installation.
1 Pull the LATCH harness and connectors
out of the current belt path OR from the
storage slots (Fig. F).
2 Align the LATCH harness in the
appropriate belt path.
Refer to figure D for rear-facing installation
OR figure E for forward-facing installation.
Verify that the harness is not twisted.
3 Follow instructions for restraint installation
with LATCH.
•
•
Switching the LATCH Harness
Restraint Functions
D
E
G
F
Release
Button Top