Bassworx BA3000.1D - Manual (Page 3)

Precautions: Read First!
-
Be sure to mount the amplifier to a strong, solid surface which will not give way under the stress of a
sudden stop or accident.
-
Make sure that the mounting screws will not penetrate the gas tank, brake and fuel lines, wiring or
other critical parts of your car when installed.
-
NEVER operate the amplifier without the proper power and ground wire - 0 gauge minimum.
-
NEVER operate the amplifier without proper fusing. Fuse holder must be located with in 18 inches
of the battery. This fuse is to protect the car, not the electronics. In case of a short, the fuse will
blow instead of the wire burning up. Using other than the recommended fuse ratings at the battery
and at the amplifier may cause damage to the amplifier and will void your warranty.
-
Do not run wiring underneath or outside the car since exposure to the elements may cause the
insulation to deteriorate rapidly, resulting in short-circuits and/or intermittent operation.
All cables should be run beneath carpets and inside trim pieces.
-
To help minimize interference, it is best to run the power cables along the opposite side from the
audio cables.
-
Whenever wires pass through metal, rubber or plastic grommets must be used to prevent the metal
from wearing through the installation and causing a short.
- Whenever possible, use cable ties, mounting clamps and similar wiring aids. Adding stress relief
loops to wiring is also advisable to prevent straining or breakage.
-
It is best to test the system before the amplifier is mounted and interior of car is reassembled.
-
If the temperature inside your car reaches extreme levels(such as sitting locked up for several hours
in the hot sun or exposed to a very cold winter's day), the amplifier may go into protection mode and
shut off. Leave the unit off until the ambient temperature returns to normal.
-
The amplifier operates with any vehicle using a 12 volt negative ground system. If you are not sure of
the type of electrical system in your vehicle, consult your authorized dealer or qualified mechanic.
-
NEVER ground the speaker leads and NEVER allow the speaker leads to come in contact with each
other. Speaker wire should be 10 gauge minimum.
-
Remote turn on wire must be switched by the radio or accessory circuit.
-
Do not listen to high volumes for extended periods of time or hearing damage may occur.
CONTINOUS EXPOSURE TO SOUND PRESSURE LEVELS OVER 100dB MAY
CAUSE PERMANENT HEARING LOSS. HIGH POWERED AUTOSOUND SYSTEM
MAY PRODUCE SOUND PRESSURE LEVELS WELL OVER 130dB. USE
COMMON SENSE AND PRACTICE SAFE SOUND.
2