Bassworx BA3000.1D - Manual (Page 4)

3
Installation
MOUNTING:
1. After reading the precautions, decide where you are going to install the unit.
2. Once the location has been determined, place the amplifier in position. Using a felt tip pen or pencil
mark the four holes to be drilled for mounting. NEVER use the amplifier as a template for drilling.
It is very easy to damage the amplifier surface in manner.
3. Drill four 1/8” diameter holes into mounting surface of steel panel. If you choose to mount on MDF
or wood panel, drill four 1/8” diameter holes into mounting surface.
4. It’s advisable to test the system before finally mounting of the amplifier.
5. Mount the amplifier using the supplied 4 self threading screws.
Installation Diagram
SELF TAP SCREWS