Slave amplifier, Master / slave preamp configuration – Bassworx BA3000.1D User Manual
Page 8
REMOCON
MASTER
SLAVER
LINE INPUT
R
L
PHASE
180°
0°
15Hz
SUBSONIC
50Hz
FILTER
L.P.F
50Hz
250Hz
GAIN
6V 0.24V
SLAVE
BASS
0dB
12dB
7
Master / Slave Preamp Configuration
is capable of running in a Master / Slave configuration. This means that two amplifers
can be ran in sync to the same subwoofer voice coil. The result of which is higher power output than
what one ampifier is capable of on the same load. Please be aware that each amplifier will see half the
impedance of your subwoofer (seeSpeaker Configuration). When an ampifier is ran in Slave mode, all
adjustments and input jacks are bypassed. The Master amplifier will dictate what is played by the Slave
unit. Simply using a single RCA cable and switching to Slave mode will run the secondary ampilfier
in this mode.
The BA3000.1D
CAR STEREO HEAD UNIT
CH1
CH2
Slave Amplifier
GND
REM
+12V