Bissell 3522 - Manual (Page 7)

7
Tip:
Your BISSELL
PowerForce features
a Quick Release
™
Cord Wrap. To
remove the Power
Cord quickly and
easily, rotate the
Upper Cord Wrap
towards floor, and
slip Power Cord from
Upper and Lower
Cord Wraps.
When you are done using your BISSELL PowerForce, return it to the Upright
position and store the Power Cord.
Turn vacuum cleaner OFF.
Unplug Power Cord by grasping the polarized plug (NOT the cord) and
disconnect from outlet.
Loop Power Cord around Cord Wraps on side of vacuum cleaner.
Clip molded plug to Power Cord to secure.
To maintain maximum performance from your BISSELL PowerForce, perform these
simple maintenance checks.
Select BISSELL PowerForce models are equipped with a Bag Change Indicator.
This indicator monitors the airflow through the Dust Bag and turns red to indicate a
reduction or blockage. The following conditions may cause it to become completely red.
Dust Bag is full; change the bag.
Dust Bag is clogged with fine materials; change the bag.
Clog in the vacuum; clear the clog.
Never reuse a Dust Bag.
Use only BISSELL Style 7 Dust Bags in your BISSELL PowerForce.
Style 7 EnviroFresh ® Micro Filtration Dust Bags (# 30861)
Style 7 Dust Bags (# 32120).
Unplug cleaner from electrical outlet.
Pull the Bag Door outward to open. Set Bag Door aside.
Grasp Dust Bag Collar, and pull Collar from Connector Tube. Discard used
Dust Bag.
Grasp new Dust Bag Collar and push firmly onto Connector Tube. Tuck in
Dust Bag.
Replace Bag Door by placing tab on bottom of door into opening as shown.
Press top of door to snap securely shut.
NOTE: Vacuum will not suction while the Bag Door is removed.
WARNING:
To
reduce the risk of electric shock, turn
Power Switch OFF and disconnect
polarized plug from electrical outlet
before performing maintenance or
troubleshooting checks.
Power Cord
Routine Maintenance
Bag Change Indicator
Tip:
Vacuuming new carpet or fine
powders may clog the Dust Bag,
causing the Bag Change Indicator to
turn red even though the Dust Bag
does not appear to be full. Change
the Dust Bag to restore maximum
performance.
1.
2.
3.
4.
1.
2.
CHANGE BAG WHEN RED
Bag Change
Indicator
3.
Replace Dust Bag
3.
4.
5.
1.
2.