Bissell 3522 - Manual (Page 9)

9
Use only BISSELL Style 7 Replacement Belts (#32074) in your
BISSELL PowerForce.
Unplug cleaner from electrical outlet.
With Rotating Floor Brush removed from vacuum cleaner ( Steps
1-4 of Check Rotating Floor Brush and Drive Belt), grasp old Drive Belt and
remove from Motor Pulley. Discard old Drive Belt.
Place new Drive Belt over Motor Pulley and stretch other end over Rotating
Floor Brush in the space between the bristles.
Place ends of Rotating Floor Brush down into slots on sides as shown.
Turn Rotating Floor Brush by hand several times in direction of Motor Pulley. If
properly installed, Drive Belt will center itself.
Reposition Brush Cover and four screws. Tighten screws securely. Make
sure end of Brush Cover is snapped into place.
(Select Models)
Use only BISSELL Replacement Bulb (#203-1007) in your BISSELL PowerForce.
Unplug cleaner from electrical outlet.
Using a Phillips head screwdriver, remove the two screws as shown and lift off the lens.
Remove the bulb from the socket by pushing in gently and turning it
counterclockwise. Install the new bulb by pushing it gently into the socket
and turning clockwise.
Reposition lens and secure with the two screws.
The Hose on the back of the vacuum cleaner that carries the dirt from the
Powerfoot to the Dust Bag can sometimes become clogged. If you notice a
change in the sound of the vacuum motor, check for clogs.
Unplug cleaner from electrical outlet.
Pull the Bag Door outward to open and set aside. Remove the Dust Bag to
check the Suction Inlet for a clog.
Grasp the Quick Reach Handle and lift up to separate from the Suction
Intake Opening. Check for a clog in the Base, the Wand or the Hose.
For models with the Twist ‘n Snap Hose. Release the hose from the
vacuum by turning to the left. Straighten the hose and unclog with a
long, narrow object.
If the clog persists, turn the vacuum cleaner OFF and unplug it. Remove
the Brush Cover. Check the Air Passageway for obstructions. Remove
debris from this area. Reposition Brush Cover and four screws. Tighten
screws securely. Make sure end of Brush Cover is snapped into place.
Clearing Clogs
3.
4.
5.
1.
2.
6.
3.
4.
1.
2.
3.
4.
1.
2.
Suction
Inlet
Air Passageway
Brush
Cover
Press here
Replace Drive Belt
Replace Light Bulb