Black & Decker F855 - Manual (Page 11)

11
8. Press and hold the Control
down until all the water has
been emptied. If necessary,
rock the iron from side to side
and front to back.
9. Release the Control and tip the
iron sideways to allow any
remaining water to drain.
10. Place the iron on its heel rest
and plug into a standard
electrical outlet. Heat for about
2 minutes to dry out any
remaining water.
IRON WON’T 1. Is the Power light on? (Press the ON/OFF
HEAT? Button).
2. If the Light is not on, will a lamp plugged into
the outlet turn on?
3. Is the Heat/Fabric Dial adjusted to a fabric
setting?
IRON WON’T 1. Check to be sure there is enough water in
START STEAMING? the Tank.
2. Is the Adjustable Steam Dial set at
(light), (medium), or (heavy)?
Adjust the Dial to Dry and back to the
desired steam level.
WATER DROPLETS 1. Is the Heat/Fabric Dial set in a steam area
COMING FROM and is the Adjustable Steam Dial set at the
STEAM VENTS? corresponding (light), (medium), or
(heavy) steam setting?
2. If water droplets continue, reduce the steam
or increase the temperature setting slightly.
Need Help?