Bose GS SERIES III 3.2.1 - Manual (Page 35)

31
S ETUP
Italiano Svenska Deutsch Nederlands English Français Español
Setting the remote for your TV
To use the 3•2•1 ® remote with your TV, you must set
the remote for the proper TV device code.
1. Refer to the list of “Device codes” on page A-1.
2. In the list for TVs, find the brand of your TV.
3.
Write down several codes for your brand so you
can try more than one, if needed.
Note:
If one code works to turn your TV on and off but
does not change channels, you can try other codes to
find one that provides more complete TV control.
4.
Turn on the TV and your 3•2•1 system.
5.
On the 3•2•1 remote, press and
hold the TV button for several
seconds.
Wait until the red light at the top of the remote
turns on.
6.
Use the number buttons on this
remote to enter the device code
for your TV.
The light turns off briefly as you
press each key.
7.
Make sure the light turns off completely after all
digits are entered.
If the light blinks now, the code is invalid. Return to
step 5 and try a different code for your TV.
8.
Point the 3•2•1 remote at your TV
and press the TV On/Off button.
Use the 3•2•1 remote to turn the TV
on again and change channels, using the
number buttons or by pressing Channel up
or down.
If it performs both operations, this code is correct.
Write the code numbers below:
If this code does not work, repeat steps 5-8
using a different code for your TV.
Note: For a CD changer or combination CD/DVD player
and changer, your brand may not be listed in the CD/DVD
device codes on page A-21. In some cases, the same
brand of DVD or VCR device codes can work with
a changer.