Bose GS SERIES III 3.2.1 - Manual (Page 36)

32
S ETUP
Italiano Svenska Deutsch Nederlands English Français Español
Controlling another component
With your CBL•SAT, VCR, or other component turned
on, follow these steps.
1.
In the Device Codes list, find the codes for the type
and brand of your component.
2.
On the 3•2•1 ® remote, press and hold the
button for this component for several
seconds.
Wait until the red light at the top of the
remote turns on.
3. Enter the device code for your component.
The light turns off briefly as you press each key.
4.
Make sure the light turns off completely after all
digits are entered.
If the light blinks instead of turning off, the code is
invalid. Return to step 2 and try a different code for
your component.
5. Point the 3•2•1 remote at your
component and press the On/
Off button for this source.
Use the 3•2•1 remote to turn
the component on again and to skip
forward by pressing channel up or down.
If it performs both operations, this code is
correct. Write the code numbers below:
If this code does not work, repeat steps 2-5
using a different code for your component.
AUX AUX
or
AUX AUX