New Buck Corporation FP-BR-10-ZC - Manual (Page 13)

INSTALLATION OF MODEL FP - BR10- ZC
WITH OPTIONAL WOODEN MANTEL
(1) When choosing the right location for your heater and mantel keep the following in mind:
NOTE: Due to high temperatures, this heater should be located out of traffic and away
from furniture and draperies.
NOTE: Kit No. (PA KDMH10) Deluxe Wooden Mantel for FP-BR10-ZC.
Kit No. (PA KDM10) Standard Wooden Mantel for FP-BR10-ZC
CAUTION: THE INSTALLATION MUST CONFORM WITH LOCAL CODES OR, IN
THE ABSENCE OF LOCAL CODES, WITH THE NATIONAL FUEL GAS CODES,
ANSI Z223.1/NFPA 54.
NOTE: See page 18 for “Gas Pressure Check”.
WARNING: YOUNG CHILDREN SHOULD BE CAREFULLY SUPERVISED WHEN
THEY ARE IN THE SAME ROOM WITH THE APPLIANCE.
DO NOT PLACE CLOTHING OR OTHER FLAMMABLE MATERIAL ON OR NEAR
THE APPLIANCE
(2) Screen(s) can not be removed or altered (Position screen(s) in the closed position before
leaving heater unattended).
(3) Follow instructions for assembly of (Optional) Wooden Mantel. See instructions supplied
with mantel.
(4) After mantel has been assembled, slide the heater from the rear into the opening of the
mantel.
NOTE: Place a cloth or blanket over the front portions of the mantel as not to scar the wood.
(5) Center the heater in the opening of the mantel. See Figure 6.
(6) Fasten mantel to hearth by using ½" wood screws.
(7) Insert the nine (9) ½" wood screws provided with mantel through slots on nailing flange
and secure in place. See Figure 6.
(8) Position mantel and fireplace into desired location.
(9) To light the heater, see “Lighting Instructions” pages 19 through 30. Make sure you have
the right gas valve for Natural or LP gas.
NOTE: Hook gas supply line into heater. Check for leaks using soap and water, not an open
flame.
NOTE: When used as a bedroom fireplace, the unit must be attached to the wall. Use the
angle provided with the mantel. Also the safety screen must be kept mechanically secured
to the unit as it is when it leaves the manufacturer.
Page 11