Best CP37 - Manual (Page 5)

- 5 -
4. MOUNT CUSTOM HOOD INTERNAL FRAMEWORK
5. REMOVE FILTERS
6. REMOVE GREASE DRIP RAIL
Remove tape on filters. Remove filters from power pack and set aside.
NOTES: 1. It is recommended to start with the center one(s).
2. On 42” width model only, for each side filters,
slide out filter filler (shaded part on illustration
beside).
HD0295
HO0113
A. Lift grease drip rail to disengage it from
the bottom panel.
B. Slide grease rail all the way to the left or
right (
1
) and lift the opposite end to
disengage the other end from the bottom
panel (
2
). Remove it from the power
pack and set aside for later use.
A
B
1
2
HD0291
HD0292
Since the CP35 and CP37 power pack mounting holes are located in front and
rear sides (see illustration beside), plan to install wood frame at front and sides
for support.
HH0102A
The CP35 and CP37 power pack is supported by the custom hood internal framework with screws provided in parts bag.
WARNING
The framework must be positively secured to wall studs or other wooden framework behind the drywall.
Make sure it is capable of supporting its own weight and the weight of the CP35 or CP37. Failure to do so
may cause personal injury or damage to countertop or cooktop.
!