Remove the blower(s), Install the power pack, Cont’d) – Best CP37 User Manual
Page 8: Caution
- 8 -
11. REMOVE THE BLOWER(S)
(CONT’D)
CP37 M
ODEL
For each blower, using a 5/16” socket, remove all blower mounting screws from the inner
top of the power pack front and rear brackets. Set aside the screws.
HD0297
For each blower, slide it to disengage its flanges from the retaining brackets. Set aside the
blowers.
B
LOWERS FRONT BRACKET
B
LOWERS REAR BRACKET
HD0298
12. INSTALL THE POWER PACK
Using provided no. 8 x 1/2” chrome plated screws, install the power pack inside
the custom hood. Start with 2 screws on front corners, then use 4 screws for
sides and use the last one to finalize securing the front power pack. (See figure
beside for mounting screw specific locations.)
Make sure the adapter/damper (or the adapter) enters the ducting. When there
is access to the top of the power pack, seal connections with duct tape.
CAUTION
Take care not to kink ducting when installing the power pack.
HH0102A