Bakers Pride LC User Manual
Page 3
(FL, CT, LC)B-XX(R, GS)
24
30
36
42
48
54
60
66
72
Number of Burners
3
4
5
6
7
8
9
10
11
G20 & G25 Gas
17.58 23.45 29.31 35.17 41.03 46.89 52.75 58.61 64.47
G30 & G31 Gas
15.82 21.11 26.38 31.65 36.93 42.20 47.48 52.75 58.03
Net Heat Input in kw (Europe)
17.58 23.45 29.31 35.17 41.03 46.89 52.75 58.61 64.47
19.53 26.06 32.57 39.07 45.59 52.10 58.60 65.11 71.63
G20 & G25 Gas
G30 & G31 Gas
Gross Heat Input in kw (Europe)
XX = 24, 30, 36, 42, 48, 54, 60, 66 or 72 (Overall width in inches)
FL = Floor Model
CT = Counter Top Model
LC = Low Profile Model
B = Broiler with Rear Gas Connection
R = Radiant Type
GS = Glo-Stone Type
Model Definition
NOTE: Description of Model Numbers and Definition of Prefixes used in this manual are shown below.
I. INSTALLATION INSTRUCTIONS
1. INSTALLATION:
(i) Installation of this broiler must conform with the latest edition of ANSI Z223.1 National Fuel Gas
Code in USA (CAN/CGA-B-149.1 or 2 Installation Code in Canada) and/or local codes.
(ii) This appliance must be installed by a competent person in accordance with the rules in force. In
U.K. Corgi registered installers (Including the regions of British Gas) undertake to work to safe and
satisfactory standards. This appliance must be installed in accordance with the current Gas Safety
(Installation and Use) Regulations and the relevant Building Regulations / IEE Regulations. Detailed
recommendations are contained in the British Standards Code of Practice BS 6172, BS 5440:Part 2
and BS 6891.
(iii) Use this Broiler only with an adequately sized exhaust hood. The room in which this broiler is
installed must be suitably vented in accordance with the National and/or local codes.
(iv)This broiler when installed must be electrically grounded in accordance with local codes, and/or
the latest edition of the National Electrical Code ANSI/NFPA No. 70 in the USA (Canadian Electrical
Code CSA Standard C22.1, Part 1 in Canada).
In Europe, the appliance must be connected by an earthing cable to all other units in the complete
installation and thence to an independent earth connection in compliance with EN 60335-1 and/or
local codes.
3