Bakers Pride LC - Manual (Page 7)

Adjustment screws for the Pilot Valves are sealed at the factory after adjustment to provide a ½" (13
mm) flame. If adjustment is required, it should be done by a factory authorized technician only, and
the screws must be sealed after the adjustment.
(v) Turn the burner control valves to ‘ON’ to light the burners.
If any burner fails to light, turn that burner valve to ‘OFF’, wait five minutes then repeat the above
procedure.
(vi) After all burners have been lit, turn all burner valves ‘OFF’ and make sure that the pilot burners
stay lit.
Each burner may now be adjusted to the desired flame size by turning the individual burner valve
handle.
TO SHUT DOWN THE UNIT, TURN ALL VALVES ‘OFF’. WAIT FIVE MINUTES BEFORE
ATTEMPTING TO RE-LIGHT.
NOTE: The Pilot Burners will stay lit until the Gas Supply to the unit is turned ‘OFF’.
(b) UNITS WITH SAFETY PILOTS
(i) Turn all broiler valves to ‘O’ position.
(ii) Open main gas shut-off valve (supplied by the customer).
(iii) For each burner, press, turn counter clockwise and hold down that burner control knob at the
pilot burner ignition position.
(iv) Using a lit taper, light that pilot burner.
(v) Release the knob after 30 seconds. Pilot burner should stay lit.
IF THE PILOT BURNER DOES NOT STAY LIT, WAIT FIVE MINUTES AND REPEAT STEPS (iii)
AND (iv). THIS TIME HOLD DOWN THE KNOB LONGER BEFORE RELEASING.
Adjustment screws for the Pilot Burner are sealed at the factory after adjustment to provide a ½" (13
mm) flame. If adjustment is required, it should be done by a Factory Authorized technician only, and
the screws must be sealed after the adjustment.
Each burner may now be adjusted to the desired flame size by turning the individual burner valve
knob
TO SHUT DOWN A BURNER, TURN THAT CONTROL KNOB CLOCKWISE TO THE PILOT
BURNER IGNITION POSITION.
TO SHUT DOWN THE PILOT BURNER AS WELL, PRESS THAT CONTROL KNOB AND TURN
CLOCKWISE TO THE ‘O’ POSITION.
WAIT FIVE MINUTES BEFORE ATTEMPTING TO RE-LIGHT.
7