Philips AquaTrio Système d'aspiration et lavage - Manual (Page 11)

11
• switch off the appliance before you pull it
over a threshold to prevent water traces on
the floor or water from splashing out of the
mopping nozzle.
• After you switch off the appliance, move
it forwards and backwards a few times to
remove the liquid that is present between
the two mopping brushes. If you switch off
the appliance and lift it up, the water that was
present between the brushes leaves a trace of
water on the floor.
C Caution:
Never tilt the upper body of the appliance too
far backwards or put the appliance on its side to
prevent leakage from the dirty water tank.
•
remove the liquid that is present between
the two mopping brushes. If you switch off
the appliance and lift it up, the water that was
present between the brushes leaves a trace of
water on the floor.
5.3 Pausing during use
1
If you want to pause for a moment, release
the power-on button to switch off the
appliance. Place the appliance in upright
position. It automatically locks in parking
position (‘click’).
5.2 Cleaning tips
• hold the handgrip in one hand and the mains
cord in your other hand to avoid tripping over
the mains cord and to prevent water traces
on the mopped floor. To have better control
over the cord, fix the mains cord behind the
cord fixing hook.
• Work backwards and in the direction of a
door to avoid walking on the mopped floor.
• Do not move the mopping nozzle sideways, as
this results in water traces on the floor.
• You can move the appliance just as quickly as
a vacuum cleaner. To remove difficult stains,
move the appliance slowly over the stain.
EN
g
LI
sh