Philips AquaTrio Système d'aspiration et lavage - Manual (Page 21)

21
12 Troubleshooting
This chapter summarises the most common problems you could encounter with the appliance.
If you are unable to solve the problem with the information below, contact the Consumer Care
Centre in your country.
Problem Possible cause solution
The appliance
does not work
when I push the
slide forwards
and press the
power-on button.
You did not assemble
the upper body
on the lower body
correctly.
Place the lower body of the appliance on the flushing
tray. Press the upper body onto the lower body with
some force until you hear a click (see chapter ‘Before first
use’). The blue back of the upper body has to fit onto the
lower body without a gap.
The upper body
wobbles and is
not stable when I
use the appliance.
You did not assemble
the upper body
on the lower body
correctly.
Place the lower body of the appliance on the flushing
tray. Press the upper body onto the lower body with
some force until you hear a click (see chapter ‘Before first
use’). The blue back of the upper body has to fit onto the
lower body without a gap.
I cannot press the
power-on button
to switch on the
appliance.
The appliance is
equipped with a
safety lock.
You first have to push the unlock slide forwards to
unlock the power-on button and then you can press the
power-on button to switch on the appliance. Release the
unlock slide when the appliance switches on, but keep
the power-on button pressed (see chapter ‘Using your
AquaTrio’).
The appliance
stopped working
and a light flashes
when I switch on
the appliance.
The clean water tank
is empty.
The tank full/tank empty light flashes to indicate that the
clean water tank needs to be refilled. Fill the clean water
tank (see chapter ‘Preparing for use’, section ‘Filling the
clean water tank’).
The clean water tank
is not present or
has not been placed
properly.
Make sure you place the clean water tank properly and
that the lever is locked (see chapter ‘Preparing for use’,
section ‘Filling the clean water tank’).
The appliance
stopped working
and a light lights
up continuously
when I switch on
the appliance.
The dirty water tank
is full.
The tank full/tank empty light lights up continuously to
indicate that the dirty water tank needs to be emptied.
Empty the dirty water tank (see chapter ‘Using your
AquaTrio’, section ‘Emptying the dirty water tank’).
The dirty water tank
is not present or
has not been placed
correctly.
Make sure you place the dirty water tank properly
and that the lever is locked (see chapter ‘Using your
AquaTrio’, section ‘Emptying the dirty water tank’).
The lid is not
assembled onto the
dirty water tank.
Assemble the lid properly. Make sure you pull unlocking
slides backwards (towards the handle) to lock the lid on
the dirty water tank (see chapter ‘Using your AquaTrio’,
section ‘Emptying the dirty water tank’).
EN
g
LI
sh