Brocade Communications Systems Brocade VDX 8770-4 - Manual (Page 75)

Brocade VDX 8770-4 Hardware Reference Manual 55
53-1002563-02
Switch fabric module removal and replacement
5
ATTENTION
Follow ESD precautions.
1. Unscrew the power enable pin.
2. Loosen the two screws on the slider using the Phillips screwdriver if necessary.
3. Pull out the pin and move the slider all the way to the left, exposing the captive screw.
4. Unscrew the two captive screws using the Phillips screwdriver.
5. Open the ejectors by rotating them toward the center of the module face. Pull the SFM out of
the chassis using the ejectors.
FIGURE 15 Removal and replacement of the switch fabric module
Replacing a switch fabric module
Complete the following steps to insert the SFM.
1. Unpack the new SFM and remove it from the anti-static bag.
2. Inspect the module for damage.
3. Remove the protective caps from the backplane connectors.
4. Unscrew the power enable pin, pull it outward, and move the slider toward the center of the
module face.
5. Open the ejectors on the new SFM by rotating them toward the center of the module face.
Orient the switch fabric module so that the ejectors are toward you.
6. Align the module pan with the guides in the slot. The first SFM should be installed in slot S1.