Bacharach PCA 2 24-9448 - Manual (Page 29)

Instruction 24-9448 3-9
Initial Setup
3.10 Time Setup
The tme s stored n the format: hh:mm:ss
AM/PM. Its value s part of the date and tme
stamp that s saved along wth each combuston
test record.
Set the analyzer’s nternal clock to the current
tme as follows:
1. Dsplay the MAIN MENU by pressng the
MENU (F2) button. If necessary, press ESC
untl MENU appears above F2.
2. Use the buttons to hghlght SETUP,
and then press ENT to dsplay the SETUP
MENU.
3. Use the buttons to hghlght TIME, and
then press ENT to dsplay the TIME MENU.
4. Frst use the buttons to move the cursor
across the screen untl t s over the dgt to
be changed, and then press the buttons
untl the desred value s dsplayed.
5. Repeat Step 4 untl the values for hour, mn-
ute, and merdem have been set.
NOTE: The value for seconds cannot be en-
tered, but are displayed and stored as part of
the combustion test record.
6. Press ENT to save the dsplayed tme values
and re-dsplay the SETUP MENU, or press
ESC to abort ths procedure and retan the old tme values.
MAIN MENU
FUEL
PRESSURE
MEMORY
SETUP
CALIBRATION
DIAGNOSTICS
STATUS
F1 F2 F3
MENU
SETUP MENU
TEMP UNITS
PRESSURE UNITS
POLLUTION UNITS
DATE
TIME
O
2
REF
PRINT PRESSURE
(more)
MENU
F1 F2 F3
TIME MENU
TIME 0 9:25 AM
05/26/06 09:25:30 AM
MENU
F1 F2 F3