Liebherr CBNes 6256 PremiumPlus BioFresh NoFrost - Manual (Page 13)

Malfunctions
Your appliance is designed and manufactured for a lengthy, reliable
operating life with no malfunctions. If a malfunction nonetheless
occurs during operation, check whether it is due to an operating
error. Please note that even during the warranty period the result-
ant servicing costs in this case will have to be borne by the owner.
You may be able to rectify the following faults by checking
the possible causes yourself:
Appliance does not function:
– Is the appliance switched on?
– Is the plug correctly fitted in the mains socket?
– Is the fuse intact?
Loud running noise:
– Is the appliance set up firmly on the floor?
– Does the appliance cause nearby items of furniture or objects to
vibrate? Please note that noises caused by the refrigerant circuit
cannot be avoided.
The temperature is not cold enough:
– Is the temperature setting correct (see "Setting the temperature")?
– Have excessive amounts of fresh food been placed in the appli-
ance?
– Does the separately installed thermometer show the correct
reading?
– Is the ventilation system working properly?
– Is the appliance set up too close to a heat source?
If none of the above causes
apply and you cannot rectify
the fault yourself, contact the
nearest customer service de-
partment stating the type des-
ignation ➊, service number ➋
and appliance number ➌ as
indicated on the type plate.
The position of the type plate is shown in the section entitled
Description of the appliance.
Shutting your appliance down
If your appliance is to be shut down for any length of time, switch
it off and disconnect the plug or switch off or unscrew the fuse.
Clean the appliance and leave the door open in order to prevent
unpleasant smells.
The appliance complies with the relevant safety regulations and
EC Directives 2004/108/EC and 2006/95/EC.
All types and models are subject to continuous improvement and
the manufacturer therefore reserves the right to make modifica-
tions to the shape, equipment and technology.
GB
4. Push down the button on the filter, tilt the filter forwards
and remove.
The dust filter can be washed in a dish-
washer or by hand using water and
detergent.
Cleaning the dust filter
1. Disconnect the appliance from the mains.
2. Pull the bottom freezer drawer right out.
3. Unscrew the ventilation grille.
5. Dry the filter and then, in reverse order, replace it.
6. Re-attach the ventilation grille.
7. Cancel the dust filter LED in the display. See Setup mode,
= Confirm dust filter cleaning.
25