Liebherr CBNPgb 3956 Premium BioFresh NoFrost - Manual (Page 7)

u Unscrew the bearing
element Fig. 5 (8) , turn it
180° and transfer it to the
opposite side. Possibly
make preliminary holes with
a bradawl or use a cordless
screwdriver.
Fig. 7
4.3.2 Detaching the upper door
Fig. 8
u Close the upper door.
u Pull off the cover Fig. 8 (10) forwards and upwards.
u Lift off the cover Fig. 8 (11) .
CAUTION
Risk of injury if the door tips!
u Take good hold of the door.
u Set down the door carefully.
u Unscrew the upper turn hinge Fig. 8 (12) (2x Torx® 25)
Fig. 8 (13) and lift it off.
u Lift off the upper door and set it aside.
4.3.3 Detaching the lower soft stop mechanism
Fig. 9
u Open the lower door.
NOTICE
Risk of damage!
If the door seal is damaged, the door may fail to close properly
and the cooling will be inadequate.
u Do not damage the door seal with the screwdriver!
u Disengage and remove the faceplate Fig. 9 (20) using a flat-
blade screwdriver.
w The faceplate is attached over the soft stop bracket.
Fig. 10
u Slide the faceplate forwards over the soft stop bracket
Fig. 10 (24) in the direction of the appliance.
u Snap the safety lock Fig. 10 (22) into the oblong hole.
w The safety lock prevents the hinge from snap-closing.
u Using a screwdriver, lift off the cover Fig. 10 (21) from the
outside and remove it in an outward direction.
u If necessary, tip the appliance backwards with the assis-
tance of a second person.
u Press the pin Fig. 10 (23) out from underneath.
u Press the soft stop bracket Fig. 10 (24) towards the door.
u Remove the faceplate Fig. 10 (20) .
u Unscrew the entire soft stop unit (2x Torx® 15) Fig. 10 (25) .
u Pull the soft stop unit out a little, push it in the direction of the
handle side and swing it out.
u Set the soft stop unit aside.
4.3.4 Detaching the lower door
u Close the lower door.
u Draw the middle bearing pin Fig. 11 (32) together with the
washer Fig. 11 (34) out of the turn hinge and lower door.
u Remove the plastic cap Fig. 11 (33) .
CAUTION
Risk of injury if the door tips!
u Take good hold of the door.
u Set down the door carefully.
u Open the lower door.
u Unscrew the middle turn hinge Fig. 11 (31) (2x Torx® 25).
u Lift off the lower door and set it aside.
4.3.5 Transferring the middle bearing elements
Fig. 11
u Carefully detach the cover panel Fig. 11 (30) .
Putting into operation
* Depending on model and options 7