Barco MDRC-2124 - Manual (Page 19)

19
Installation
Connecting the display
Use only the power adapter, power cord, and the video cables shipped
with this display.
To setup this display, please refer to the following figure and
procedures.
1. Be sure all equipment is turned off.
2. Connect the DC power cord to the power connector; plug one
end of the AC power cord into the power adapter, and the
other end into an electrical outlet. ( ).
3. For a PC with DisplayPort output, connect the DisplayPort
signal cable from the display DisplayPort input connector to
the DisplayPort connector of your host computer. ( ).
4. For a PC with DVI digital output, connect the DVI signal cable
from the display DVI-I input connector to the DVI connector of
your host computer. Tighten the screws ( ).
5. Turn on your computer, display and video source.