BlueAnt T1 - Manual (Page 3)

Pair Your T1
1. Turn the T1 on by
sliding the power
switch on the back to
the green on position.
2. Put the T1 in your ear.
3. The fi rst time you use the T1 it will go straight to pair
mode and talk you through the pairing process.
For subsequent pairings, make sure the T1 is not
connected to any phones, then hold down the MFB. The T1
will announce that it is going into pairing mode.
Tip: The pairing code is 0000 (four zeros).
3
Power switch (on)
Transfer Your Phonebook
Once the pairing is complete, your T1 will attempt to transfer
your phonebook contacts so that it can announce the names
of incoming callers. Please accept any connection requests
from the T1 and wait for the transfer to fi nish.
Some phones do not support automatic phonebook
transfers. If the T1 announces that this is the case, you need
to go to your phone’s address book and send contacts via
Bluetooth to the T1. See www.blueantwireless.com for help.
Note: Whenever you add contacts to your phone in future
you must update your phonebook on the T1: with the T1
connected to your phone but not on a call, hold down the
MFB for 3 seconds to initiate a phonebook update.
4