BlueAnt T1 - Manual (Page 8)

Reset your T1
If you are having problems with the T1, you can reset the T1
and your phone and start again:
1. Disconnect the T1 from your phone by deleting the pairing
from your phone’s Bluetooth menu.
2. Turn your phone off and back on again to clear its memory.
3. With the T1 switched on, but not connected to any phones,
click all three buttons ( Vol + , Vol - , and the MFB) together.
Note that you must quickly press and release all three
buttons at the same time (do not hold down the buttons).
The T1 will reset and go straight to pairing mode.
You will now need to pair your phone with the T1 again.
13 Troubleshooting Tips
The following are some troubleshooting tips for using the T1
with specifi c phone models.
Phonebook Transfers
When you pair your phone the T1 will attempt to transfer the
contacts from your phonebook so that it can announce the
names of incoming callers.
Note: If your phone prompts you to allow a connection to the
T1, you must select “YES” or “OK”.
14