Best WPD28I - Manual (Page 7)

- 7 -
9. INSTALL THE BLOWER
Assemble barrel nut (packed with blower) approximately
1 ⁄
2
way onto threaded stud on top inside of hood.
Lift blower to top inside of hood. Slide blower back to
engage blower tab with slot in hood top and slot in blower
with barrel nut.
Use a long, flat-bladed screwdriver to tighten the barrel
nut securely. Plug motor into receptacle, on exterior
side of the wire box.
HD0054
S LOT IN
TOP OF HOOD
D ISCHARGE
OPENING
D ISCHARGE
OPENING
B ARREL NUT ON
THREADED STUD
B LOWER MOTOR
B ARREL NUT
F LAT - BLADED
SCREWDRIVER
HD0061
8. CONNECT WIRING
WARNING
Risk of electrical shock. Electrical wiring must be done by qualified personnel in accordance with
all applicable codes and standards. Before connecting wires, switch power off at service panel and
lock service disconnecting means to prevent power from being switched on accidentally.
!
Punch out the knock-out hole located on back side of the hood.
Remove the hood wiring box cover. Install the wire clamp on the back side of the wiring box. Pass power cable through
the wire clamp in the wiring box. Tighten wire clamp completely to secure the cable. Connect cable into wiring box using
provided waterproof wire connectors.
W ATERPROOF WIRE CONNECTORS INSTRUCTIONS :
1. Strip wires 3 ⁄
8
’’.
2. Align frayed strands or conductors.
3. Do not pre-twist. Place stripped wires together with ends even, but lead
smaller stranded wires slightly ahead of larger solid or stranded wire.
4. Twist connector onto wires pushing firmly until hand-tight. DO NOT over
torque.
5. When inserting wires into connectors, some sealant may leak out. Wipe
off excess sealant in and around conductors. DO NOT REUSE.
Connect wires as follow: BLACK wire from power cable to BLACK wire from hood control panel (A), all WHITE wires
together (B), BLACK wire from wiring box to ORANGE wire from hood control panel (C), and GREEN or BARE wire
under ground screw (D). DO NOT FORGET TO CONNECT THE GROUND. Reinstall the wiring box cover.
HE0048
A
B
D
C