Bissell PowerSteamer 1690 - Manual (Page 9)

1. Slowly move Upholstery/Carpet Tool back and
forth over soiled surface, first using spray only,
then spray and vacuum, finishing with
vacuum only.
NOTE: Use the Spraying Crevice Tool [optional
on some models] to spray cleaning solution and
remove soil from areas too small to be reached
with the Upholstery/Carpet To o l .
2. Continue to clean soiled area, working in
small sections, until no more dirt can be
removed. Do not overwet.
3. If the machine loses suction and/or motor
noise rises in pitch, turn Power Switch to OFF.
Check the Dirty Water Tank Assembly and
empty the tank if it is full [see WHEN YOU’RE
DONE, page 7].
4. If spray tip stops spraying, turn Power Switch
to OFF and check water and cleaning solution
levels. Refill if needed.
Never run POWERSTEAMER
TM dry.
Cleaning
15. Select SmartClean TM setting.
• WATER ONLY - Use for gentle cleaning of delicate
fabrics, or for (optional) rinsing following cleaning.
• NORMAL - Water and Fiber Cleansing Formula are
mixed to optimize normal cleaning. Use for everyday
dirt and soil conditions.
• HIGH TRAFFIC - Water and Fiber Cleansing Formula are
mixed to optimize heavy cleaning. Use for entryways,
hallways, heavy soil and stains.
This setting may require more frequent refilling on the
SmartMix
TM bottle.
16. Unwrap Power Cord from Cord Holder and plug into
120 Volt, 60 Hz grounded outlet as described in Important
Safety Instructions, page 2.
If cleaner starts when first
plugged in, switch off until
ready for use.
9
WARNING:
U s e
o n l y B I S S E LL F i b e r
Cleansing Formula
™ i n
your POWERSTEAMER. ™
Use of cleaning formulas
which contain lemon
or pine oil may damage
this appliance and void
w a r r a n t y. Chemical spot
cl eane rs or sol vent-
based soi l re movers
sho ul d n ot be used.
These products may
react with the plastic
materials used in your
P O W E R S T E A M E R,
™ c a u s i n g
cracking or pitting.
WARNING:
D o
not l ay unit on its
back wit h Clean
Water Tank Assembly
in place. Do not tip
up foot with Dirty
Water Tank Assembly
in place.