Philips Daily Collection Kaffeemaschine User Manual

Page 10

Advertising
background image

troubleshooting

This chapter summarises the most common problems you could encounter with the appliance. If

you are unable to solve the problem with the information below, contact the Consumer Care

Centre in your country.

Problem

Possible solution

The appliance does not work.

Plug in and switch on the appliance.
Make sure that the voltage indicated on the appliance

corresponds to the local mains voltage.
Fill the water tank with water.
In all other cases, contact the Philips Consumer Care Centre.

Water leaks out of the appliance. Do not fill the water tank beyond the MAX level.

In all other cases, contact the Philips Consumer Care Centre.

The appliance takes a long time

to brew coffee.

Descale the appliance (see chapter ‘Descaling’).

The appliance produces a lot of

noise and steam during the

brewing process.

Make sure that the appliance is not blocked by scale. If

necessary, descale the appliance (see chapter ‘Descaling’ ).

The filter overflows when

I remove the jug from the

appliance while it is brewing

coffee.

If you remove the jug from the hotplate while the appliance is

brewing coffee, place the jug back onto the hotplate as soon

as possible to prevent the filter from overflowing. Also note

that the coffee does not reach its full taste before the end of

the brewing cycle. Therefore we advise you not to

remove the jug and pour out the coffee before the end of the

brewing cycle.

Coffee grounds end up in the jug. Make sure that the water tank cover is in place before you

put the ground coffee in the filter.
Do not put too much ground coffee in the filter.
Place the jug correctly under the filter holder.
Unclog the opening in the bottom of the filter holder.
Use the right size of paper filter (1x4 or no. 4).
Make sure the paper filter is not torn.

The coffee is too weak

Use the right proportion of coffee to water.
Make sure the paper filter does not collapse.
Use the right size of paper filter (1x4 or no. 4).
Make sure there is no water in the jug before you start to

brew coffee.

The coffee does not taste good.

Do not leave the jug with coffee on the hotplate too long,

especially not if it only contains a small amount of coffee.

The coffee is not hot enough.

Place the jug properly on the hotplate.

EnglisH

10

Advertising