Blaupunkt SR04 - Manual (Page 12)

11
Installation
Installation in a Vehicle: Mounting the AMERICA SR04
(Do not insert the AMERICA SR04 into the Car Cradle until the following steps are complete)
1. Determine where in the vehicle you would like the unit to be mounted.
• Find a location where it easy to view the front display of the unit.
• Do not install the unit:
– On the windshield where it may interfere with your clear view of the road.
– In front of an air conditioning vent.
– In a place where it may hinder with vehicle controls.
– In the direct deployment area of the vehicle air bag system. Doing so may cause severe injury
or possibly death.
2. Thoroughly clean the area where you will mount the car cradle to promote maximum adhesion.
3. Remove the protective covering away from the adhesive tape on the bottom of the car cradle and
stick the car cradle to the desired location. Apply firm pressure for a minimum 15 seconds.
4. If possible, reinforce the car cradle mount with the supplied mounting screws. When doing so, be
sure to check where the screw(s) may protrude on the backside to ensure that they will not damage
any wiring or structural points of the vehicle.
5. Connect the cigarette lighter power adapter to the back of the car cradle. Wait until the installation
is complete to connect to the vehicle’s cigarette lighter receptacle. It is recommended that when not
in use, disconnect the cigarette lighter power adapter from the outlet.
6. Audio Connection from the AMERICA SR04 to your vehicle radio can be done two ways:
• If your radio has AUXILIARY input, you can use the supplied audio cable to connect from the
AUDIO OUT of the AMERICA SR04 Car Cradle to the AUX input of your radio.
OR
• The AMERICA SR04 has an onboard 12 channel Wireless FM Modulator. To access this, enter
the MAIN MENU and select FM TRANSMITTER. (Details on how to navigate through the MENU