Blaupunkt SR04 - Manual (Page 14)

13
Installation
Installation in a Vehicle: Running the Antenna Cable
After you have determined that the unit was temporarily installed correctly, and you had connection to
SIRIUS Satellite Radio, you should permanently install the cables for the system. This will allow for a
clean installation, and prevent any possibilities of driver or passengers of the vehicle tripping over or
interfering with the cables.
1. Disconnect the antenna cable from the AMERICA SR04 Car Cradle.
2. Starting with the Antenna, from the mounting location of the antenna, carefully track the antenna wire
back into the vehicle cabin. Look for any pre-existing wire channels or conduit that will allow for easy
tracking through the vehicle.
• Avoid sharp metal edges where damage may occur to the antenna cable.
• Avoid direct metal pinch points, such as the area of the door hinge, where damage may occur to
the cable.
• Avoid extra slack in the cable in the area where the driver or passengers place their feet. This may
cause injury to the driver or passengers, and potentially damage the antenna cable.
• Absolutely do not attempt to cut and/or patch the antenna cable. Any slack in the cable should be
gathered and neatly wire tied behind an interior panel.
3. Track the cable to the rear of the car cradle and gently insert it into the receptacle labeled ANT.