West Bend Back to Basics Coffeemaker - Manual (Page 5)

5
4. Replace the lid on to the mixing container, making sure that the lid covers the
pour spout.
5. Plug the Hot Drink Maker into a 120 volt, AC outlet only.
6. Press the “ON” switch. Your Hot Drink Maker will begin to mix and heat. When
the mixture reaches the “Perfect Temperature” the appliance will automatically
go idle. At anytime during the mixing and heating process, you may press the
“OFF” switch to turn the appliance off. Note: A full 32 ounces takes
approximately 6-8 minutes.
7. Once the appliance automatically goes idle, place a cup underneath the
dispensing valve and press the “FROTH/DISPENSE” switch. This switch will
mix the beverage while you dispense so that a rich layer of froth is dispensed
into your cup along with the hot drink.
8. Press down on the dispensing valve lever to dispense the hot drink into your cup
while the motor is mixing the beverage. After dispensing the beverage, press
the “CANCEL” switch.
9. When the container has less than 1 cup of liquid remaining or is empty, press
the “OFF” switch. Note: The appliance will remain on until you switch it off.
INGREDIENTS CHART
CUPS
1 2 3 4
LIQUID
Milk/Water 8 oz. 16 oz. 24 oz. 32 oz.
POWDER MIX
with Milk 2 tbsp. 4 tbsp. 6 tbsp. 8 tbsp.
POWDER MIX
with Water 4 tbsp. 7 tbsp. 11 tbsp. 14 tbsp.
Note:
Different instant cocoa, coffee, and tea mixes may vary from the quantities
shown in this chart. Use the quantities specified on the packaging of the specific
instant hot drink mix for exact measurements.
“PERFECT TEMPERATURE” FEATURE
The Cocoa~Latte
™
Hot Drink Maker is designed to maintain the “perfect
temperature.” Once the hot beverage reaches the “perfect temperature,” you will
hear the motor stop running and the mixing paddle stop mixing. The appliance is
now idle but still “ON.” Once the hot beverage cools down, the unit will automatically
reheat and remix back to the “perfect temperature.” You may at any time press the
“OFF” switch to turn the unit off. THE APPLIANCE WILL CONTINUE TO CYCLE
ON and OFF UNTIL THE “ON/OFF” SWITCH IS TURNED TO THE “OFF”
POSITION.