Britax Multi-Tech BB0-702-00 - Manual (Page 10)

3. Installing your child seat (rearward facing) in rear middle seat
Open both lock-offs. Pull off suffi cient
lap and diagonal belt (
approx. 600-
900mm ). Feed the belt through the
lock-off belt guide on the opposite side
to the buckle and in to the belt tunnel
(dia 3b) . There are two access slots in
the seat cover to aid feeding of the belt
through the belt tunnel and underneath
the seat cover
(dia 3b inset) .
Feed the seat belt through the belt
tunnel and lock-off on the opposite side
and attach the tongue into the buckle
(dia 3c) .
IMPORTANT - The child seat MUST only be used with a lap or a lap and
diagonal seat belt (approved to UN/ECE regulation no. 16 or equivalent
standards).
With the footprop adjusted to the shortest length, place the child seat rearward
facing on the car seat with the back of the child seat positioned centrally
between the driver and passenger seat and with the swinging base resting
against the back of the vehicle seat
(dia 3a) .
3a
3c
Pull all the seat belt slack through the child seat ensuring the seat belt is not
twisted. When the belt is as tight as possible, close the lock-off on the seat belt
buckle side, ensuring that both the lap and diagonal sections of the belt are
secured by it
(dia 3d inset) .
Close the lock-off on the opposite side, ensuring that only the lap section of the
belt is secured by it
(dia 3d) .
Ensure that both lock-offs have been clicked into place.
If the buckle now lies in the position marked as wrong with a and the seat
belt cannot be correctly tightened (dia 3e) , try another seating position in the
car.
3e
3b
3d
Britax_2h.indb 10 30/10/2007 16:23:57