Britax Multi-Tech BB0-702-00 - Manual (Page 12)

4. Installing your child seat (rearward facing) in front seat
Open both lock-offs. Pull off suffi cient
lap and diagonal belt (
approx. 600-
900mm ). Feed the belt through the
lock-off belt guide on the side opposite
to the buckle and in to the belt tunnel
(dia 4b) . There are two access slots in
the seat cover to aid feeding of the belt
through the belt tunnel and underneath
the seat cover
(dia 4b inset) .
Feed the seat belt through the belt
tunnel and lock-off on the opposite side
and attach the tongue into the buckle
(dia 4c) .
IMPORTANT - The child seat MUST only be used with a lap or a lap and
diagonal seat belt (approved to UN/ECE regulation no. 16 or equivalent
standards).
Push the vehicle front seat back to accommodate the child seat ensuring that
any passenger directly behind will still be able to sit in a comfortable position.
With the footprop adjusted to the shortest length, place the child seat rearward
facing with the swinging base resting against the back of the vehicle seat
(dia
4a) .
IMPORTANT - DO NOT rest the back of the child seat on the dashboard or
close to the windscreen.
4a
4c
Pull all the seat belt slack through the child seat ensuring the seat belt is not
twisted. When the belt is as tight as possible, close the lock-off on the seat belt
buckle side, ensuring that both the lap and diagonal sections of the belt are
secured by it
(dia 4d inset) .
Close the lock-off on the opposite side, ensuring that only the lap section of the
belt is secured by it
(dia 4d) .
Ensure that both lock-offs have been clicked into place.
If the buckle now lies in the position marked as wrong with a and the seat
belt cannot be correctly tightened (dia 4e) , try another seating position in the
car.
4e
4b
4d
Britax_2h.indb 12 30/10/2007 16:24:01