Burris XT-120 - Manual (Page 16)

4. Rotate the rocker switch to one side
until it clicks “ON.”
5. While aiming through the weapon’s
iron sights, adjust the visible aim point
of the XT-120 with the provided
adjusting (hex) tool until the aiming
point of the beam is superimposed
over the firearms’s iron sight aiming
point (see diagram).
6. Fire three rounds into the center of the
target aiming point at 25 meters.
7. Compare the impact point of the shot
group with the beam’s aiming point.
8. Make additional adjustments as
necessary until the beam coincides
with your point of impact.
9. Turn the XT-120 OFF.
Laser Spot
Front Iron Sight
Rear Iron Sight
14