Broadband Products AMC-6 - Manual (Page 17)

4
Entering Settings
N
Changing Transponder Frequencies
Note: This section was included in the manual for future changes – Do NOT change current settings
at this time.
WARNING: It is necessary to follow this step-by-step procedure closely. Altering these settings out of
sequence or entering invalid data can disable your satellite connection and necessitate a software
reinstall.
1. Double left click your mouse button on the round satellite signal (either red or green) next to
the clock on the Task Bar (Figure 4-1).
Figure 4-1
This will open your Setup4PC window as shown in Figure 4-2.
Figure 4-2
2. Left click your mouse on the Transponder Management button as shown in Figure 4-3.
17