Broadband Products AMC-6 - Manual (Page 4)

Static Electricity Warning
To prevent static damage to electronic components, observe the following precautions:
Ì Touch an anti-static or grounded surface such as a large metal object to discharge static from
your body before you remove the electronic components from their packaging and before touching
system components.
Ì Handle system components only at the corners. Never touch any of the metal parts of the
electronic components, such as the golden pins that plug into the slot.
Installing The Internal B2C2 Satellite PCI Modem
To install the internal PCI satellite modem, first insure that the computer is turned off. Following your
PC manufacturer’s instructions, do the following:
1. Turn the PC off and unplug the power supply.
2. Open the side panel or rear cover of your computer to expose the PCI slots.
3. Choose an empty PCI slot you want to place the board in. Unscrew the slot’s metal dust protector
located on the back cover of the case. Lay the protector to one side.
4. Hold the internal PCI satellite modem so that the satellite modem’s IC chips are facing downward,
the metal contacts are toward the PCI slot.
5. Insert the internal PCI satellite modem firmly into the PCI slot as shown in Figure 1-1.
Figure 1-1
6. Tighten the screw on the rear of the internal PCI satellite modem so that it is firmly secured to the
computer chassis (if available).
7. Replace the access cover of your computer case.
4