Broadband Products AMC-6 - Manual (Page 19)

Figure 4-5
5. This will now show your Edit Transponder window. Please check to make sure that the
Transponder is set to 11726, the Symbol Rate is set to 8000, the FEC is set to ¾ and the
Polarity is set to Horizontal/Left (High). If any of your settings are different, please change
them now to the correct settings (Figure 4-6).
Figure 4-6
6. If you have to make any changes, this will highlight the Tune button (Figure 4-7). If you didn’t
have to make any changes, just retype the Transponder to highlight the Tune button. Left
click on the Tune button after making your changes and the Network will change from No
Information to Acquiring…. After the Network changes back to No Information, right click on
the round satellite signal (either red or green) in the Task Bar next to the clock and then left
click on AMC-6 :: StarConnect (Figure 4-8).
19