Philips 711714050 - Manual (Page 13)

•Press the steam switch (5), the LED
situated within the switch will light up.
The machine ready LED situated within
the coffee switch (4) will light up.
•Wait until the machine ready LED
situated within the switch (4) switches
off; the machine is now ready to supply
steam.
• Point the steam tube (Pannarello)
over the drip tray and open the “hot
water/steam” knob (6) for a few
seconds to clear the tube of any excess
water. Wait for a few more seconds for
steam to flow out.
•Close the knob (6).
• Immerse the tube in the liquid to
be heated and open the knob (6).
Move the container gently up and
down to ensure that the liquid is heated
right through.
•When the liquid has reached the
required temperature close the knob
(6) and turn off the “steam” switch (5).
•Proceed following the pr iming
instructions found in para. 4.6.
•To make a cappuccino heat milk using
the method explained above.
• When you have finished using the
steam tube clean with a damp cloth.
9 Cleaning instructions
Before cleaning the machine, let it cool
down and unplug it.
•Do not immerse the coffee maker in
water and do not put any of the
components in a dishwasher.
•Do not use sharp objects or abrasive
chemical products (solvents) to clean
the machine.
• Clean the water tank and fill it with
fresh water daily.
24 25
HOT WATER JET / CAPPUCCINO / CLEANING INSTRUCTIONS COFFEE FLOW / ADVICE ON CHOICE OF COFFEE
turning it in an anti-clockwise direction
and press the coffee switch (4).
•Wait until a steady stream of water flows
from the tube (Pannarello).
•Press the coffee switch (4) again and
close the “hot water/steam” knob (6),
turning it in a clockwise direction.
The machine is now ready to make a
perfect cup of coffee.
5 Coffee flow
Warning! Do not remove the filter
holder by turning it manually in
a clockwise direction while the machine
is producing coffee. Danger of burning.
•During this operation the „machine on“
light inside the coffee switch (4) will go
on and off. This is perfectly normal.
•Before using the machine, make sure
that the “hot water/steam” knob (6) is
closed and that there is sufficient water
in the tank.
•Turn on the machine. If the coffee
maker is not working the light on the
inside of the main switch (3) will light
up. Wait until the machine ready LED
situated within the coffee switch (4)
switches off; the machine is now ready
to supply coffee.
•Place the filter (12) in the pressure
locking filter holder (11).
• Fit the filter holder into the coffee
outlet socket (7), pushing it upwards
and turning it to the right until it locks
into place.
•Let go of the filter holder handle.
Automatically the handle will move
slightly to the left. This movement
guarantees the perfect functioning of
the filter holder.
• Place a cup under the filter holder.
To warm up the filter holder and the
cup, press the coffee switch (4); water
will begin to drip from the filter holder
(this operation is only necessary for the
first cup of coffee).
•When the cup is sufficiently full, press the
coffee switch (4) again.
• Remove the filter holder from the
machine by turning it to the left and
pour out any water that is left inside.
•If the special pressure locking filter
holder (11) is used, the same filter can
be used for one or two cups of coffee.
• To make one or two cups of coffee,
add 1 or 2 even measures of ground
coffee to the filter.
• Fit the pressure locking filter holder
(11) into the coffee outlet socket (7), as
explained before, pushing it upwards
and turning it to the right until it locks
into place.
• Position two warmed cups under
the filter holder, making sure that they
are directly under the coffee spouts.
•Press the coffee switch. Wait until the
cups are sufficiently filled.
•Press the coffee switch again to stop
the coffee flow.
• When the coffee flow has ceased,
remove the filter holder and empty out
the excess coffee grounds.
Cleaning hint: when cleaning the filter
take it right out of the filter holder and
rinse thoroughly.
6 Advice on choice of coffee
Practically any type of ground coffee on
the mar ket can be used with this
machine.
Coffee is a natural product and its taste
varies, depending on its origin and blend.
It is therefore advisable to try a number
of different types to discover your own
personal preference.
For best results use blends specifically
ground for espresso machines. The
coffee flow should be constant and
should not drip. The speed of the coffee
flow can be regulated by changing the
dosage, the fineness of the grinding and/
or by how heavily you tamp down the
coffee in the filter.
BEFORE USING THE HOT WATER/
STEAM JET, MAKE SURE THAT THE
STEAM TUBE (PANNARELLO) IS
POSITIONED OVER THE DRIP TRAY.
7 Hot water jet
•If the machine is not already on, turn it
on at the main switch (3) which will light
up.
•Wait until the LED situated within the
coffee switch (4) switches off.
• Place a cup or a glass tea cup
under the steam tube (Pannarello).
•Open the “Hot water/steam knob (6),
turning it in anti-clockwise direction
and press the coffee switch (4) to start
the water flow.
•To stop the water flow, press the coffee
switch (4) again, and close the steam
knob (6) by turning it in a clockwise
direction.
Danger of burning!
When water begins to flow out,
it may be very hot. The steam tube does
get very hot, so avoid touching it in any
way.
8 How to prepare a cappuccino
coffee using the steam tube
•If the machine is not already on, turn it
on at the main switch (3) which will light
up.
20
21
22
19
20
21
22
23
18
24
27
15