Cassette playback, Cassette tape recording – Hyundai H-1409 User Manual
Page 4
4
FM and FM stereo reception
· Set the BAND switch to FM position, programmer is received in mono mode.
NOTE: In particular when stereo signal is weak and much noise are received, it is preferable to receive the programmer in mono.
·
Set the BAND switch to FM ST position, programmer is received in stereo mode, thus FM STEREO indicator should light up.
Cassette playback
· Slide the FUNCTION switch to TAPE position.
· Press the STOP/EJECT button to open the cassette compartment.
· Insert a cassette and push the cassette door to close the cassette compartment.
· Press the PLAY button to start the playing.
· Adjust the level and quality of sound with VOLUME knob.
NOTE:
· Press the PAUSE button to pause the playing.
· Press the STOP/EJECT button to stop the playing, press the button again to open the cassette door and you can take out the tape.
· When the tape plays to the end, playing will be stopped automatically and releases the PLAY button at the same time.
· Press the "STOP" button followed by the "REWIND" or "FAST-FORWARD" button to rewind or forward the tape at high speed.
Cassette tape recording
· Open the cassette door by pressing the "STOP/EJECT" cassette Button.
· Insert a blank cassette with the tape-side up, into the proper Guide-rails on the inside of the cassette door.
· Gently push the cassette door forward (inwards) to close it.
· Make sure the tape is fully and properly inserted before doing so.
· The set is now ready to start recording, which can be done from either the radio or CD-player.
Recording from radio
· Set the FUNCTION switch to RADIO position.
· Tune to the desired station by turning the TUNING knob.
· Press the PLAY button and RECORD button on deck simultaneously to start recording.
Recording from CD
· Set FUNCTION switch to CD position.
· Press RECORD and PLAY buttons simultaneously to start recording.
· Press the PAUSE button.
· Start the CD-player and select the exact song to be recorded.
· Release the PAUSE button to start recording.