Bunn H5M - Manual (Page 9)

9
SERVICE
This section provides procedures for testing and
replacing various major components used in this dis-
penser should service become necessary. Refer to
Troubleshooting for assistance in determining the cause
of any problem.
Component Access
WARNING – Disconnect the dispenser from the power
source before the removal of any panel or the replace-
ment of any component.
The limit thermostat, liquid level probe, tank heater,
and temperature sensor are located at the top of the
dispenser. Access is gained by removing the top lid,
attached with three 4-40 slotted-head screws.
WARNING – Inspection, testing, and repair of electrical
equipment should be performed only by qualified ser-
vice personnel. Disconnect the dispenser from the
power source when servicing, except when electrical
tests are required and the test procedure specifically
states to connect the dispenser to the power source.
Contactor ............................................................ 17
Limit Thermostat ................................................ 10
Liquid Level Board .............................................. 15
Safety Overflow Switch ....................................... 11
Solenoid Valve .................................................... 12
Tank Heater ........................................................ 13
Control Thermostat ............................................. 14